ECU DETAILS

Airbag No Crash 6 performs crash data clearing for Audi TT 8N (98-06) airbag control unit with part number Bosch 8N0 959 655 B. You can reset airbag unit by programming the device MC68HC912B32 (0J64Y) and remove the stored crash data after your airbags have deployed. This operation will enable you to reuse the unit without having to buy an expensive new SRS module from the Dealer. The airbag control module will function and operate exactly as it did prior to the airbag light coming on, leaving you with a safe airbag control/restraint system.

When you can use Airbag No Crash 6:
• if your airbags deployed
• airbag errors due to a discharged or flat battery or by jump starting attempts
• if your airbag light is flashing or constantly on
• if your diagnostic tool is reading Crash Data Stored, Crash Recorded, ECU error etc.

Before use Airbag No Crash 6:
• check communication between your diagnostic tool and airbag ECU
• check all the wiring circuits and fuses (it could be that your ECU is faulty)

Airbags and airbag control units are designed to only work once. Airbag No Crash 6 will clear the existing crash/error data so that they can be used again. They will function as new, erasing the crash data will cost much less than the cost of a new unit.

If your airbags have deployed then obviously they need to be replaced with un-deployed air bags but the original airbag ECU can now be repaired and cleared of all its crash data.

If you have not had an accident and for some reason your vehicle indicates an airbag system fault, then this can be an internal airbag control unit error. In this case, it is NOT recommended to restore the unit.

To restore this ECU you need to own the authorization:

Every authorization can process as many files as you want. No more need to pay!

This authorization unlock these applications too: